NStor Technologies Disk Array Enclosure Manual de usuario Pagina 74

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 92
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 73
Maintenance
Replacing a Fuse
62
3 Loosen the two thumb screws that secures the card.
4 Insert the new I/O Interface card and tighten the thumb screws. Do not
overtighten the fasteners.
5 Using the packaging materials from the replacement card, repackage the
failed card and return it to nStor Corporation. Refer to the nStor Resource
Guide for information on “Obtaining a Return Material Authorization.”
Replacing a Fuse
CAUTION: Power off the subsystem and disconnect the power cord before
changing the fuse.
1 Locate the fuse holder on the rear panel of the CR8e.
2 Using a small coin, turn the fuse holder counter-clockwise one quarter turn,
releasing the holder from its locked position.
Fuse Assembly
Power Connector Module
250V
Fuse (250V 10A)
Fuse Holder
Vista de pagina 73
1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 91 92

Comentarios a estos manuales

Sin comentarios