NStor Technologies Disk Array Enclosure Manual de usuario Pagina 27
- Pagina / 92
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Installation
Rack-Mount Subsystem Assembly
15
Rack-Mount Subsystem Assembly
You can install the CR8e into any standard IAE 19" rack cabinet.
CAUTION: Ensure that the location of the CR8e does not create an unstable
condition when installed in the rack cabinet enclosure.
NOTE: Mount the subsystem into the rack enclosure before installing the disk
drives. This will reduce the weight required to support during installation.
1 Select an appropriate location in your rack cabinet for the CR8e. If you are
installing multiple systems, review the cabling configuration section later in
this chapter for your cable scheme to determine the optimum locations.
A
8-32 Pan Head
Screws
8-32 Caged
Nuts
Washers
Front Rack Vertical
Rear Rack Vertical
- Regulatory Information 3
- Power Cord Selection 4
- Contents 5
- Features 10
- Where to Find Answers 11
- Registering Your Product 12
- Getting Started 13
- CR8e Subsystem at a Glance 14
- Components 16
- I/O Interface Card 18
- Power Cord Connector and Fuse 18
- Configuration Modules 19
- Controlling and Monitoring 20
- Power-On LED 21
- Status Indicator LEDs 21
- Status LEDs 22
- Activity LEDs 22
- Alarm Speaker 23
- Fault LEDs 23
- SAF-TE Card 23
- Installation 25
- System Requirements 26
- Guidelines 26
- Rack-Mount Subsystem Assembly 27
- Component Installation 29
- Cabling Configuration 32
- Termination 33
- Ultra Wide SCSI Mode 34
- Single-Bus Enclosure 36
- Fast Wide SCSI Mode 38
- Two Dual-Bus Enclosures 40
- Two Single-Bus Enclosures 44
- Other Configurations 48
- Using the CR8e 49
- Firmware Error Conditions 50
- SAF-TE LED Matrix 51
- Operator Control Panel 52
- Power Supply Error Conditions 53
- Subsystem Status Icon 53
- Main Menu 54
- POST Results 56
- Internal Temp 57
- Options Menu 58
- Reset Default IDs Selection 60
- Heat Threshold 61
- SAFTE CHAIN ID 62
- Change Passcode 63
- OPTIONS WILL REMAIN 64
- UNLOCKED UNTIL YOU 64
- RETURN TO THE 64
- DEFAULT SCREEN 64
- Troubleshooting 65
- Common SCSI Bus Problems 66
- Maintenance 69
- Replacing a Power Supply 70
- Replacing the Cooling Fans 72
- Thumb Screw 73
- Replacing a Fuse 74
- Replacing the CR8e Cabinet 75
- Glossary 77
- Technical Information 81
- CONNECTORS AND JUMPERS 82
- JP3 (SCSI-to-SCSI IDs) 85
- JP4 (SCSI ID Settings) 86
- JP5 (SCA Remote/Delay start) 87
- J15 (FAN) and J17 (OEM FAN) 88
AirLive VoIP 400 Series podręczniki
Instrukcje obsługi i podręczniki użytkownika dla Networking AirLive VoIP 400 Series.
Dostarczamy 1 pdf podręczników AirLive VoIP 400 Series do pobrania za darmo według typów dokumentów: Podręcznik Użytkownika
Comentarios a estos manuales